Acrylic Latex Coating
Description
High performance acrylic latex coating for roof waterproofing and heat reduction.
Technical Information
| Appearance: White1 thick liquid | Solubility: 100% | |
| Foaming: None | Odor: Paint | |
| Density: 10.2 Lbs./Gal. | pH Level: 8.0 | |
| Flash Point: None | Stability: Stable |
1
can be made to almost any desired colorDirections
Apply to clean, firm concrete, wood, metal and built up roof surfaces at rate of 50 to 100 ft2 per gallon by spraying, rolling or brushing. Mechanically agitate before use. Roll, brush, or spray using crosshatch method (apply each pass at a 90o angle to preceding coat). Make sure each coat is fully cured (2-4 hrs at 70oF 50% humidity) before proceeding with multiple light applications building up to the desired dry film thickness. Recommend that two applications be-made the first being a water thinned primer coat. Do not apply on wet surface or when rain is expected within 12 hours. The higher the humidity the longer coating will take to cure. Coating must be totally dry before rain to avoid blisters or wash off. Do not apply on wet, dirty, contaminated surfaces. Reseal container after each application. Clean up with water.
Material Safety
Do not freeze. Mix well before using. Avoid inhalation of mist if spray applied. Properly dispose of unused containers. Do not take internally. Keep out of the reach of children. If swallowed, induce vomiting and seek medical attention.
[Back to Section 2 - Concrete And Masonry Maintenance Products - Sealers And Coatings]