Concrete Acrylic Emulsion Seal

Description

A water based sealer suitable for multiple uses. Can be used on marble, slate, terrazzo, quarry tile and concrete. Can be applied to new concrete as a curing compound and will give a durable surface seal. Water based, solvent free product that eliminates hazards associated with solvent based sealers. Resistant to abrasion and to a wide variety of chemicals to give long life and wear. Easy repair by coating directly over old surface after cleaning. Dries quickly to a high shine. This acrylic polymer is modified for use as a sealer and gives a tough, clear and non-yellowing surface film.

Technical Information

Appearance: White Emulsion Solubility: 100%
Solids: 25% Odor: Mild
Density: 8.44 Lbs./Gal. pH Level: 9.0
Stability: Good Residual Monomer: Less than 0.5%
Flash Point: None

Directions

When used outdoors make sure that temperature is above 45oF and will not drop below that level for 12 hours. Exceptionally low odor material that makes it attractive for indoor application as well as outdoor. Do not apply to a wet surface or if rain is expected within 12 hours. Apply by spraying or brushing on surface. Application ratio is about 200 square feet per gallon.

Material Safety

Keep from freezing.

[Back to Section 2 - Concrete And Masonry Maintenance Products - Concrete]