Repel – 10 – MB + UV

Description

A solvent based reactive siloxane which will penetrate all porous surfaces and react to form a durable water repellent surface and subsurface. Specially modified to repel ultraviolet damaging rays.

Technical Information

Directions

Masonry should be completely dry before Repel 10 - MB + UV is applied. Treatment should not be started if temperature is below freezing as the possibility of entrapped water exists. A spray application is preferred but brush on applications can be just as successful. Take care in making sure equipment is clean and gaskets and hose are solvent resistant. Coverage should be no more than 200 square feet per gallon. For spraying use a coarse low pressure spray pattern and thoroughly wet the surface. Hold nozzle about 6 inches from surface and move nozzle so that the solution runs down about 6 to 10 inches from the point of application. Allow sufficient drying time. Do not apply to wet surface or when rain is expected within 12 hours.

Material Safety

Contains Petroleum Distillate. Keep away from heat, sparks and flame. Avoid prolonged breathing of vapors. Avoid contact with eyes or prolonged or repeated contact with skin. For skin contact flush thoroughly with water. For eye contact flush for 15 minutes and seek medical attention.

[Back to Section 2 - Concrete And Masonry Maintenance Products - Sealers And Coatings]