Silicone Water Repellent

Description

Properly applied will form a water repellent surface that will cause water to bead up on surface. The use of silicone retards or prevents changes in the surface appearance by resisting the deterioration effects of many types of weathering.

Technical Information

Directions

Masonry should be completely dry before Silicone Water Repellent is applied. Treatment should not be started if temperature is below freezing as the possibility of entrapped water exists. A spray application is preferred but brush on applications can be just as successful. Take care in making sure equipment is clean and gaskets and hose are solvent resistant. Coverage should be no more than 200 square feet per gallon for each application. For spraying use a coarse low pressure spray pattern and thoroughly wet the surface. Hold nozzle about 6 inches from surface and move nozzle so that the solution runs down about 6 to 10 inches from the point of application.

Material Information

Protect plants and shrubs from this product. It has a harmful effect on many types of plants. Protect all shrubs and plants by covering with a drop cloth. For accidental contact with window be sure to clean as soon as possible. Unless removed, this product will cloud window glass to some extent. Contains Mineral Spirits. Avoid contact with eyes and skin and breathing of vapors. Use in well ventilated area. Should not be used in confined spaces or around combustion sources.

[Back to Section 2 - Concrete And Masonry Maintenance Products - Sealers And Coatings]